Edgecam m&h Probing Systems

Edgecam supports m&h touch probes. Edgecam supports m&h touch probes. Users can measure workpieces and simulate the probe movements with six individual measuring cycles. Each cycle has been enhanced with eight new functions, giving a wider choice of inspection data.

EDGECAM M&H PROBING SYSTEMS EN DETALLE

Edgecam supports m&h touch probes. Users can measure workpieces and simulate the probe movements with six individual measuring cycles. Each cycle has been enhanced with eight new functions, giving a wider choice of inspection data.

Probe

Select a probe from the ToolStore. A selection of probes are available or you can create your own combinations of body, extensions and probe stylus.

Probe Surface cycle

Use this cycle to detect the position of a surface, and update the machine’s current datum by the deviation from the expected position. When creating the cycle you select a point on the surface.

Probe 4th Axis cycle

Use this cycle to measure the slope of a surface, and update the rotation of the machine’s 4th axis by the deviation from the expected slope. When creating the cycle you select two points on the surface

Probe Feed

Protected positioning moves to probe safely into position. If there is a probe trigger during a protected positioning move, EMERGENCY STOP occurs and an error message appears on the screen.

Cycles offer a number of ways to touch the part and establish a point(s) that can be used for various functions (see below) such as update a datum, check position or size.

Probe Corner cycle

Use this cycle to measure an internal or external corner and update the current datum by the deviation from the expected position.

Probe Bore/Boss cycle

Use this cycle to detect the position of a circular component, and update the machine’s current datum by the deviation from the expected position. When creating the cycle you select an arc on the bore/boss. From this the centre position and diameter are derived.

Probe Web/Pocket cycle

Use this cycle to detect the position of a web or pocket, and update the machine’s current datum by the deviation from the expected position. When creating the cycle you select two points, on either side of the web, or on opposite walls of the pocket.

Galería